| Click here to select a new forum. |
| Quicksilver ticking from PSU when plugged in but switched off |
Posted by: Alex on 2015-01-04 13:04:11
Hello
My powermac G4 Quicksilver has a patterned ticking noise that appears to emit from the power supply even when the machine is switched off.
Does anyone have any idea what might be causing this and what the resolution might be.
If you need a video I can quickly make one.
Thanks in advance.
PS The machine otherwise works as expected and ticking disappears when the machine is turned on.
|
Posted by: Macdrone on 2015-01-04 13:18:34
Whatever the pieces control the standby voltage is probably the issue.
Short of taking it apart or replacing might never really know.
|
Posted by: Alex on 2015-01-04 13:32:23
I posted a video of the issue. https://www.icloud.com/photostream/#A25Uzl7VCaEhI
I hope it helps you fine folks get a better idea of what is going on.
Thanks a bunch!
|
Posted by: techknight on 2015-01-04 18:43:00
Since it still runs, its possible the 5VSB doesnt have an adequate load anymore and its going into overshoot trip. a open smoothing capacitor on its secondaries would cause this. Also an open load resistor on the output section would cause this as well. probably dried broken solder joint creating an open.
Especially if its high hours, it could have a bad filter cap on the 5VSB.
|
| 1 |