68kMLA Classic Interface
This is a version of the 68kMLA forums for viewing on your favorite old mac. Visitors on modern platforms may prefer the main site.
| Click here to select a new forum. | | Question about 3D Printing an entirely new Bezel for my Centris / Quadra 650 | Posted by: ml1978 on 2026-09-21 13:31:45
I apologize if my question is ignorant, but I don't own a 3D Printer and I am mostly unaware of the limitations of 3D Printing. Would it be possible to just design and print an entirly new face/front bezel to go onto the Centris / Quadra 650? If so, could a person take it a step further and redesign the front appearance to appear more like the Quadra 700 while keeping buttons and drive openings accurate as well as designing a badge location or other means of logo-ing the Centris 650 name so it would look correct while standing on its side? | Posted by: Byrd on 2026-09-21 14:52:31
Hi,
It's possible but you would need a clean scan and a large format printer to print in one piece; additional design ideas usually have to be DIY learning particular modelling program well. On the OEM part the Centris 650 badge can be pushed out to possible make it look like a tower, sort of. | | 1 |
|