68kMLA Classic Interface
This is a version of the 68kMLA forums for viewing on your favorite old mac. Visitors on modern platforms may prefer the main site.
| Click here to select a new forum. | |
| Simple mounting solution for SE/30 speaker | |
| Posted by: Zitruskeks on 2023-01-19 06:45:00 I had to remove the speaker from the faceplate of my SE/30 and was looking for a simple, non-permanent, adhesive-free way to reattach the speaker. I designed a super simple washer that sits firmly on the speaker cone and allows the metal chassis to also hold the speaker in place. If you want to print your own: Printables
www.printables.com
| |
| Posted by: ymk on 2023-01-19 08:21:13 Nice work. Looks like it sits on the metal frame rather than the paper cone. If it sat on the cone, the speaker wouldn't work all that well. Probably a good print for TPU filament. | |
| Posted by: Zitruskeks on 2023-01-19 08:22:34 Yea the metal frame. Bad wording i guess from my side 🙂 I change it! | |
| Posted by: olePigeon on 2023-01-19 10:22:50 Nice. Simple and effective. How thick is it? Could also cut one out of foam using a laser cutter. | |
| Posted by: Zitruskeks on 2023-01-19 10:27:15 Its 3,50 mm in Thickness, so its sits snug, but not overly tight using the original rubber pad between the speaker and the front. Foam would be rather stiff to be ableto bridge the gap between the mac chassis touching it on the rear and the point where it sits on the frame of the speaker. | |
| 1 |