| Click here to select a new forum. |
| Bootable SC20 with IBM disk |
Posted by: maz on 2019-10-06 10:07:36
Hi all, I am trying to make an SC20 bootable connected to a Plus. It's had its old drive replaced by an 80Mb IBM drive at some point. I can read and write from and to the drive, but I can't boot from it. What am I doing wrong?
Thanks!
-- maz
|
Posted by: dochilli on 2019-10-06 13:25:19
Did you format the hdd with lido? I had success with my hdd with lido.
|
Posted by: maz on 2019-10-13 05:57:44
Yeah, used both Lido 7 and the patched HDSC Setup (for non-Apple disks)... it still won't boot. I can read and write to and from fine after booting from a floppy.
|
Posted by: bibilit on 2019-10-13 08:46:25
IIRC something to do with the way the drive is formated.
Interleave should be set to 3:1 and a terminator is mandatory.
http://www.ccadams.org/se/hard_disk.html
|
Posted by: maz on 2019-10-13 12:43:10
Yeah, but I can both read and write once I've booted from a floppy. It's not a hardware/formatting issue. I am pretty sure I need a special driver to boot of the drive as it's a nonstandard 80MB IBM disk and not a 20MB miniscribe as I gather was shipped in the original 20SC. How do you guys boot from a SCSI device configured like this?
-- maz
|
Posted by: Scott Baret on 2019-10-14 09:29:29
Try Silverlining. I've ben able to use it for all of my non-Apple disks.
|
Posted by: MOS8_030 on 2019-10-14 10:29:04
Yeah, used both Lido 7 and the patched HDSC Setup (for non-Apple disks)... it still won't boot. I can read and write to and from fine after booting from a floppy. Which version of HD SC Setup did you use? Sounds like the SCSI driver that the Plus needs to boot isn't being copied to the disk during setup.
You might try the early version that comes with System 6. (patched of course) I forget the version number.
Also, some early Plus's have buggy ROMS regarding SCSI. (Although this is probably not the problem.)
Also the System folder on the HD needs to be "blessed".
|
Posted by: maz on 2019-10-15 10:10:12
Which version of HD SC Setup did you use? Sounds like the SCSI driver that the Plus needs to boot isn't being copied to the disk during setup.
You might try the early version that comes with System 6. (patched of course) I forget the version number.
Also, some early Plus's have buggy ROMS regarding SCSI. (Although this is probably not the problem.)
Also the System folder on the HD needs to be "blessed". I used version 3.0.1.
I just installed OS7.1 on the hard disk from a set of 10 floppies. Still can't boot. How do I tell if the system folder is "blessed"?
-- maz
|
| 1 |