68kMLA Classic Interface

This is a version of the 68kMLA forums for viewing on your favorite old mac. Visitors on modern platforms may prefer the main site.

Click here to select a new forum.

PowerMac 6100 - CD Audio Cable Adaptor?

Posted by: maceffects on 2012-05-22 18:29:02 I have a PowerMac 6100 that I want to add a CD Burner to, it doesn't seem to read disks with it in, and I thought MAYBE since the cable on the SCSI CD-R drive was different (Standard for other Macs) than the odd one on the 6100 I need some sort of adapter or cable? Would that cause an issue, the drive sounds good and doesn't appear to be bad it spins the cds but won't read anything (unless I am missing a driver?)

Posted by: maceffects on 2012-05-22 18:57:54 Attached is a picture of the two drives on the rear (Black one is OEM) the other is Labeled as "Lacie 8x4 Pana" Ideas?

Posted by: uniserver on 2012-05-22 20:26:11 i think if you force it , it should go on, I'm sure pin to pin is the same,

Posted by: maceffects on 2012-05-22 20:53:15 I tried that acutally the the ones on the newer one are much smaller then the ones on the original one from the 6100. And still not sure if that would even cause it not to read anything from it since its only Audio... But who knows

Posted by: uniserver on 2012-05-22 22:12:15 id pull the wires out of the header and solder the four wires to the pins 🙂

Posted by: Bunsen on 2012-05-23 00:12:24 Missing the audio cable should absolutely not cause a failure to read disks. I have run a 61xx without that cable in the past. I suggest you direct your troubleshooting efforts elsewhere. i think if you force it , it should go on, I'm sure pin to pin is the same, This is literally the worst advice ever. Please, don't anyone ever do this.

1