68kMLA Classic Interface
This is a version of the 68kMLA forums for viewing on your favorite old mac. Visitors on modern platforms may prefer the main site.
| Click here to select a new forum. | | Announcing ZuluSCSI - A file-based SCSI device emulator | Posted by: aperezbios on 2023-07-14 19:21:04
@Brooklyn It sounds like one or more of your ZuluSCSI boards may be operating in "raw passthrough" mode. If that's the case, the LED on the ZuluSCSI will blink three times upon initialization (to indicate it didn't find a valid image file OR filesystem).
Currently, the only way to change the SCSI ID on a board that's using raw passthrough mode is at compile time. You could, however, create an image of the existing SD card, using something like win32diskimager, or, any other raw disk read utility, and then name that file HDn.xyz, where N is the SCSI ID you desire. | Posted by: Brooklyn on 2023-07-15 14:14:05
@Brooklyn It sounds like one or more of your ZuluSCSI boards may be operating in "raw passthrough" mode. If that's the case, the LED on the ZuluSCSI will blink three times upon initialization (to indicate it didn't find a valid image file OR filesystem).
Currently, the only way to change the SCSI ID on a board that's using raw passthrough mode is at compile time. You could, however, create an image of the existing SD card, using something like win32diskimager, or, any other raw disk read utility, and then name that file HDn.xyz, where N is the SCSI ID you desire. Thanks, I was able to get everything to work by formatting the SD cards exFAT with MBR partition table. Then using a blank image file from Blue SCSI. All good now, just thought if I initialized on the Macintosh it would auto create the image files but it doesn’t work that way. | | < 14 |
|